Navigation

Springe zum Hauptinhalt
Universitätsbibliothek
Universitätsbibliographie

Ergebnis der Datenbankabfrage

Nr. Titel Autor Jahr
1 Fabrication and Characterization of Al2O3 Based Electrical Insulation Coatings Around SiC Fibers Palaniyappan, Saravanan* et al. 2019
2 Hydrogen embrittlement of a quenching and partitioning steel during corrosion and zinc electroplating Mehner, Thomas* et al. 2019
3 Influence of cutting speed on the surface properties in turning of Fe17Cr2Ni0.2C iron based thermally sprayed coatings Liborius, Hendrik et al. 2019
4 Influence of SiC particle volume fraction and texture on the surface properties in milling of AMCs with MCD-tipped tools Clauß, Benjamin* et al. 2019
5 Mechanical test procedures for the evaluation of hydrogen-assisted damage in high-strength steel Kröger, Benjamin* et al. 2019
6 Pitting corrosion behavior of a laser hardened, high-alloyed steel Mehner, Thomas* et al. 2019
7 Pulse plating of Pd-Ag alloy films from deep eutectic solvents Manolova, Mila* et al. 2019
8 Strain-rate sensitive ductility in a low-alloy carbon steel after quenching and partitioning treatment Frint, Philipp* et al. 2019
9 Corrosion characteristics of a quenching and partitioning steel determined by electrochemical impedance spectroscopy Lampke, Thomas et al. 2018
10 Corrosion characteristics of a quenching and partitioning steel determined by electrochemical impedance spectroscopy Mehner, Thomas et al. 2018
11 Influence of titanium on microstructure, phase formation and wear behaviour of AlCoCrFeNiTix High-Entropy Alloy Löbel, Martin* et al. 2018
12 Residual-stress evolution of cold-rolled DC04 steel sheets for different initial stress states Mehner, Thomas* et al. 2018
13 Archaeometric case studies on decorations of pre-Columbian pottery using X-ray spectroscopy maps and profiles Dietrich, Dagmar* et al. 2017
14 Detection and Prediction of Corrosion-Affecting Parameters in Cold Flat Rolling Processes Bauer, Alexander* et al. 2017
15 Macromechanical finite-element simulations for predicting microstructures by experimental calibration Mehner, Thomas et al. 2017
16 Microstructure and Wear Resistance of AlCoCrFeNiTi High-Entropy Alloy Coatings Produced by HVOF Löbel, Martin* et al. 2017
17 The Phase composition and microstructure of AlχCoCrFeNiTi alloys for the development of high-entropy alloy systems Lindner, Thomas* et al. 2017
18 Zeitaufgelöste Korrosionsprüfung mittels elektrochemischer Impedanzspektroskopie Mehner, Thomas et al. 2017
19 Zusammenhänge zwischen Werkstoff- und Oberflächenzustand und der Korrosionsanfälligkeit von Metallen Mehner, Thomas 2017
20 Experimental and numerical investigation on cold flat rolling processes of DC04 sheets with special focus on residual stresses Bauer, Alexander* et al. 2016
Aktuelle Seite:
Anzahl der Ergebnisseiten: 2
Anzahl der Dokumente: 36

Presseartikel

Soziale Medien

Verbinde dich mit uns: